Struct d1_pac::audio_codec::ac_dac_drc_ctrl::R

pub struct R(/* private fields */);

Register ac_dac_drc_ctrl reader

Implementations

impl R

pub fn dac_drc_et_en(&self) -> DAC_DRC_ET_EN_R

Bit 0 - DRC ET enable

pub fn dac_drc_lt_en(&self) -> DAC_DRC_LT_EN_R

Bit 1 - DRC LT enable

pub fn dac_drc_delay_func_en(&self) -> DAC_DRC_DELAY_FUNC_EN_R

Bit 2 - Delay function enable

pub fn dac_drc_signal_func_sel(&self) -> DAC_DRC_SIGNAL_FUNC_SEL_R

Bit 3 - Signal function select

When the signal function selects the Peak filter, the RMS parameter is unused. (AC_DRC_LRMSHAT, AC_DRC_LRMSLAT, AC_DRC_LRMSHAT, AC_DRC_LRMSLAT)

When the signal function selects the RMS filter, the Peak filter parameter is unused. (AC_DRC_LPFHAT, AC_DRC_LPFLAT, AC_DRC_RPFHAT, AC_DRC_RPFLAT, AC_DRC_LPFHRT, AC_DRC_LPFLRT, AC_DRC_RPFHRT, and AC_DRC_RPFLRT)

pub fn dac_drc_detect_noise_en(&self) -> DAC_DRC_DETECT_NOISE_EN_R

Bit 4 - Control the DRC to detect noise when ET is enabled.

pub fn dac_drc_gain_min_limit_en(&self) -> DAC_DRC_GAIN_MIN_LIMIT_EN_R

Bit 5 - DRC gain min limit enable When this function is enabled, it will overwrite the noise detect function.

pub fn dac_drc_gain_max_limit_en(&self) -> DAC_DRC_GAIN_MAX_LIMIT_EN_R

Bit 6 - DRC gain max limit enable

pub fn dac_drc_delay_buf_en(&self) -> DAC_DRC_DELAY_BUF_EN_R

Bit 7 - The delay buffer use or not when the DRC is disabled and the DRC buffer data output completely.

pub fn signal_delay_time_setting(&self) -> SIGNAL_DELAY_TIME_SETTING_R

Bits 8:13 - Signal delay time setting

Delay time = 8*(n + 1) fs, n less than 30

When the delay function is disabled, the signal delay time is unused.

pub fn drc_dealy_buffer_data_output_state( &self, ) -> DRC_DEALY_BUFFER_DATA_OUTPUT_STATE_R

Bit 15 - DRC delay buffer data output state when The DRC delay function is enabled and the DRC function is disabled. After disabling the DRC function and this bit goes to 0, write the DRC delay function bit to 0.

Methods from Deref<Target = R<AC_DAC_DRC_CTRL_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<AC_DAC_DRC_CTRL_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<AC_DAC_DRC_CTRL_SPEC>> for R

fn from(reader: R<AC_DAC_DRC_CTRL_SPEC>) -> Self

Converts to this type from the input type.