Struct d1_pac::spi_dbi::spi_batc::W

pub struct W(/* private fields */);

Register spi_batc writer

Implementations

impl W

pub fn wms(&mut self) -> WMS_W<'_, 0>

Bits 0:1 - Work Mode Select

pub fn ss_sel(&mut self) -> SS_SEL_W<'_, 2>

Bits 2:3 - SPI Chip Select

pub fn spol(&mut self) -> SPOL_W<'_, 5>

Bit 5 - SPI Chip Select Signal Polarity Control

pub fn ss_owner(&mut self) -> SS_OWNER_W<'_, 6>

Bit 6 - SS Output Owner Select

pub fn ss_level(&mut self) -> SS_LEVEL_W<'_, 7>

Bit 7

pub fn tx_frm_len(&mut self) -> TX_FRM_LEN_W<'_, 8>

Bits 8:13 - Configure the length of serial data frame of TX

pub fn rx_frm_len(&mut self) -> RX_FRM_LEN_W<'_, 16>

Bits 16:21 - Configure the length of serial data frame of RX

pub fn tbc_int_en(&mut self) -> TBC_INT_EN_W<'_, 24>

Bit 24 - Transfer Bits Completed Interrupt Enable

pub fn tbc(&mut self) -> TBC_W<'_, 25>

Bit 25 - Transfer Bits Completed

pub fn msms(&mut self) -> MSMS_W<'_, 30>

Bit 30 - Master Sample Standard

pub fn tce(&mut self) -> TCE_W<'_, 31>

Bit 31 - Transfer Control Enable

pub unsafe fn bits(&mut self, bits: u32) -> &mut Self

Writes raw bits to the register.

Methods from Deref<Target = W<SPI_BATC_SPEC>>

pub unsafe fn bits(&mut self, bits: REG::Ux) -> &mut Self

Writes raw bits to the register.

Safety

Read datasheet or reference manual to find what values are allowed to pass.

Trait Implementations

impl Deref for W

type Target = W<SPI_BATC_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl DerefMut for W

fn deref_mut(&mut self) -> &mut Self::Target

Mutably dereferences the value.

impl From<W<SPI_BATC_SPEC>> for W

fn from(writer: W<SPI_BATC_SPEC>) -> Self

Converts to this type from the input type.