Struct d1_pac::spi0::spi_batc::R

pub struct R(/* private fields */);

Register spi_batc reader

Implementations

impl R

pub fn wms(&self) -> WMS_R

Bits 0:1 - Work Mode Select

pub fn ss_sel(&self) -> SS_SEL_R

Bits 2:3 - SPI Chip Select

pub fn spol(&self) -> SPOL_R

Bit 5 - SPI Chip Select Signal Polarity Control

pub fn ss_owner(&self) -> SS_OWNER_R

Bit 6 - SS Output Owner Select

pub fn ss_level(&self) -> SS_LEVEL_R

Bit 7

pub fn tx_frm_len(&self) -> TX_FRM_LEN_R

Bits 8:13 - Configure the length of serial data frame of TX

pub fn rx_frm_len(&self) -> RX_FRM_LEN_R

Bits 16:21 - Configure the length of serial data frame of RX

pub fn tbc_int_en(&self) -> TBC_INT_EN_R

Bit 24 - Transfer Bits Completed Interrupt Enable

pub fn tbc(&self) -> TBC_R

Bit 25 - Transfer Bits Completed

pub fn msms(&self) -> MSMS_R

Bit 30 - Master Sample Standard

pub fn tce(&self) -> TCE_R

Bit 31 - Transfer Control Enable

Methods from Deref<Target = R<SPI_BATC_SPEC>>

pub fn bits(&self) -> REG::Ux

Reads raw bits from register.

Trait Implementations

impl Deref for R

type Target = R<SPI_BATC_SPEC>

The resulting type after dereferencing.

fn deref(&self) -> &Self::Target

Dereferences the value.

impl From<R<SPI_BATC_SPEC>> for R

fn from(reader: R<SPI_BATC_SPEC>) -> Self

Converts to this type from the input type.