Module d1_pac::tcon_lcd0::lcd_cpu_if

LCD CPU Panel Interface Register

Structs

• LCD_CPU_IF_SPEC
  LCD CPU Panel Interface Register
• R
  Register lcd_cpu_if reader
• W
  Register lcd_cpu_if writer

Enums

• CPU_MODE_A
  Set the cpu interface work mode
• RD_FLAG_A
  The status of read operation.
• TRI_EN_A
  Enable trigger mode
• TRI_FIFO_BIST_EN_A
  Entry address is 0xFF8
• TRI_FIFO_EN_A
  Enable the trigger FIFO
• WR_FLAG_A
  The status of write operation.

Type Aliases

• AUTO_R
  Field auto reader - Auto transfer mode
• AUTO_W
  Field auto writer - Auto transfer mode
• CA_R
  Field ca reader - Pin A1 value in 8080 mode WR/RD execute
• CA_W
  Field ca writer - Pin A1 value in 8080 mode WR/RD execute
• CPU_MODE_R
  Field cpu_mode reader - Set the cpu interface work mode
• CPU_MODE_W
  Field cpu_mode writer - Set the cpu interface work mode
• DA_R
  Field da reader - Pin A1 value in 8080 mode auto/flash states
• DA_W
  Field da writer - Pin A1 value in 8080 mode auto/flash states
• FLUSH_R
  Field flush reader - Direct transfer mode
• FLUSH_W
  Field flush writer - Direct transfer mode
• RD_FLAG_R
  Field rd_flag reader - The status of read operation.
• TRI_EN_R
  Field tri_en reader - Enable trigger mode
• TRI_EN_W
  Field tri_en writer - Enable trigger mode
• TRI_FIFO_BIST_EN_R
  Field tri_fifo_bist_en reader - Entry address is 0xFF8
• TRI_FIFO_BIST_EN_W
  Field tri_fifo_bist_en writer - Entry address is 0xFF8
• TRI_FIFO_EN_R
  Field tri_fifo_en reader - Enable the trigger FIFO
• TRI_FIFO_EN_W
  Field tri_fifo_en writer - Enable the trigger FIFO
• TRI_START_R
  Field tri_start reader - Software must make sure that write ‘1’ only when this flag is ‘0’.
• TRI_START_W
  Field tri_start writer - Software must make sure that write ‘1’ only when this flag is ‘0’.
• WR_FLAG_R
  Field wr_flag reader - The status of write operation.